SIMATIC – ET 200pro motor starter
GWA 4NEB 950 5661-02 DS 04
2-3
2.3 Requirements
The requirements for the example are:
• You have set up an S7 station, consisting of a power supply assembly and a master
with DPV1 capability (e.g. CPU 315-2 DP(1), no.: 6ES7315-2AG10-0AB0). For this
example, a CPU 315-2 DP(1) has been used as DP master.
It goes without saying that any other DPV1 master (standard IEC 61784-1:2002 Ed1
CP 3/1) can also be used.
• STEP7 (V 5.3 or higher with SP2) is completely installed on your PG. You have knowl-
edge of STEP7.
• The PG is connected at the DP master.
Note
You will find information on the operation of STEP7 in the online help.
2.4 Installation
Warning
Dangerous electrical voltage! Can lead to electrical shocks and burns. Before
starting work, disconnect the system from the power supply.
Unused connections must be closed off with standard accessory components.
The following diagram shows you the order in which you assemble the
ET 200pro components on the module holder.
Figure 2-1: Components and configuration for the example
Interface
module
Maintenance
Isolating module
DSe,
standard
Wide module holder
Terminating module
8DI
A1 A4A2 A3 A5
Infeed
Motor connection
Power jumper
Sealing cap
Sealing cap
ON
OFF
O
To Next Page
Loading...
