Siemens SIMATIC ET 200pro - Table D-9: Read Signals in the Logbook - Events

Data formats and data records
SIMATIC - ET 200pro motor starter
D-14 GWA 4NEB 950 5661-02 DS 04
The following signals can be entered:
ID no. Events – signals Note
Warnings
324 Temperature sensor overload ± (incoming / outgoing event)
325 Temperature sensor wire break ± (incoming / outgoing event)
326 Temperature sensor short circuit ± (incoming / outgoing event)
327 Thermal motor model overload ± (incoming / outgoing event)
331 Circuit breaker overload ± (incoming / outgoing event)
334 I
e
limit value exceeded ± (incoming / outgoing event)
335 I
e
limit value undershot ± (incoming / outgoing event)
337 Residual current detected ± (incoming / outgoing event)
340 Asymmetry detected ± (incoming / outgoing event)
342 Earth fault detected ± (incoming / outgoing event)
351 Input Warning ± (incoming / outgoing event)
Actions
310 Emergency start active ± (incoming / outgoing event)
357 Operating mode Automatic + (only incoming event)
358 Operating mode Manual bus + (only incoming event)
359 Operating mode 'Manual operation local' + (only incoming event)
360 Manual operation connection abort ± (incoming / outgoing event)
363 Maximum pointer deleted + (only incoming event)
365 Incorrect parameter value + (only incoming event)
ID no. of the incorrect parameter + (only incoming event)
366 Parameter change illegal in the ON state + (only incoming event)
ID no. of the incorrect parameter + (only incoming event)
368 Parameter block CPU / Master ON ± (incoming / outgoing event)
369 Factory setting restored + (only incoming event)
371 Memory module defective + (only incoming event)
373 Memory module programming successful + (only incoming event)
374 Memory module programming defective + (only incoming event)
376 FW download successful + (only incoming event)
1302 Logbook – trips deleted + (only incoming event)
1303 Logbook – events deleted + (only incoming event)
Table D-9: Read signals in the logbook – events