Siemens SIMATIC ET 200pro - Description; 1.1 Overview

SIMATIC – ET 200pro motor starter
GWA 4NEB 950 5661-02 DS 04
1-1
Description 1
1.1 Overview
1.1.1 Base components
The following table shows the fundamental components required for a configu-
ration with motor starters.
Component Function Drawing
Wide module
holder
(for motor
starter)
... is the mechanical holder in which the rear
wall bus modules of the ET 200pro are lined
up and on which the electronic modules and
motor starter are firmly screwed.
... can be ordered in the lengths 0.5 m, 1 m,
2m
(see manual Decentralized peripheral sys-
tem ET 200pro).
Interface
module
IM 154-. DP
standard /
high feature
... connects the ET 200pro with the PROFI-
BUS-DP master and prepares the data for
the electronic modules and motor starter
connected.
(see manual Decentralized peripheral sys-
tem ET 200pro).
Terminating
module
... terminates the bus at the last module
(enclosed with the interface module IM 154-
.).
Rear wall bus
module for
motor starter
and special
modules
... handles the bus supply, feeds through the
supply voltage for the electronics and actua-
tor control and accommodates:
• a special module
• a motor starter DSe (standard or high fea-
ture), sDSSte / sDSte
• a reversing starter RSe (standard or high
feature), sRSSte / sRSte
(see Chapter 6).
Table 1-1: Base components