SIMATIC - ET 200pro motor starter
4-8 GWA 4NEB 950 5661-02 DS 04
4.5 LED displays
4.5.1 Diagnosis maintenance isolating module (RSM)
4.5.2 Diagnosis of safety local maintenance isolating module (F-RSM)
Red Group error SF
LED
Status/Cause/Remedy
SF
1)
Operating status
Red Device error (device diagnosis detected by interface module IM 154-.)
1) Status of the LED in this form only with activated group diagnosis
Red Group error SF
1)
POWER L2 active Green
Yellow 1-channel
operation acti-
vated
1-CHANNEL
RUN Output /
F0 busbar
active
Green
Yellow 2-channel
operation acti-
vated
2-CHANNEL
FAULT
2)
EMER-
GENCY OFF /
EMER-
GENCY STOP
tripping
Red
Green Start signal
active
START
Green Output set OUT1
1 ) Status of the LED in this form only with activated group diagnosis
2) Flashes after switching on for approx. 7 s due to self-test, change in the connection assignment during operation or
defect in the electronics
To Next Page
Loading...
