Siemens SIMATIC ET 200pro - Figure 3-1: Installation Position

SIMATIC - ET 200pro motor starter
3-2 GWA 4NEB 950 5661-02 DS 04
Assembly rules for the installation of an ET 200pro with motor starters
Observe the following rules for assembly (See also illustrations in Chapter 1.2
"Configuration options for ET 200pro"):
• Installation in a single line on the wide module holder.
• Each line begins on the left with an interface module 154-.
• The decentralized peripheral system ET 200pro ends with the terminating
module; motor starter additionally with a covering cap for connection X3.
Installation position
The decentralized peripheral system is suitable for the following assembly on a
vertical wall:
Figure 3-1: Installation position
Please note
For your installation, please bear the following points in mind:
• Any required derating as of an ambient temperature of t
u
40°C for motor
starters (see Chapter 3.3).
vertical horizontal
ON
OFF
O
ON
OFF
O