SIMATIC - ET 200pro motor starter
10-36 GWA 4NEB 950 5661-02 DS 04
10.13 Factory setting
Description
The 'Factory setting' function enables you to restore the settings defined when
the motor starter was delivered. In this way, you can reset the motor starter if it
has been incorrectly parameterized.
Restoring the factory setting
You can restore the factory setting using the 'Factory setting' command.
You can only do this when the 'manual' operating mode is set and the switching
elements are switched off.
Once the factory setting has been successfully restored, the motor starter is in
the 'automatic' operating mode.
Signals
This device function delivers the following signals:
Signals Meaning
Factory setting restored
1)
All the parameters once again have the val-
ues set at the factory
1) Signaling bits that can be reset using "Trip reset".
Table 10-24: Factory setting – signals
To Next Page
Loading...
