Siemens SIMATIC ET 200pro - Table 10-17: Device Parameters for Response to Bus Failure - Settings

SIMATIC – ET 200pro motor starter
GWA 4NEB 950 5661-02 DS 04
10-29
Substitute value
In the event of a bus failure, a corresponding substitute process image of the
outputs controls the motor starter.
Example:
Caution
This device parameter is only relevant if you have parameterized 'Switch substi-
tute value' at 'Response to CPU / master STOP'.
10.9.2 Device parameters for response to bus failure – settings
The following table shows the settings of the device parameters:
Substitute value
Motor CLOCKWISE Reserved
Motor COUNTER-CLOCK-
WISE
Reserved
Brake Reserved
Trip reset Reserved
Emergency start Reserved
Self-test Reserved
Reserved Disable quick stop
(only for HF starters)
Device parameters Default Adjustment range
Response to CPU / master STOP Switch substitute
value
Switch substitute
value /
retain the last value
Substitute value 0 7 x (0 or 1)
Table 10-17: Device parameters for response to bus failure – settings