Siemens SIMATIC ET 200pro - Diagnosis Via HW Config in STEP7; Figure 2-5: View in the Status Window DP Slave Diagnosis

SIMATIC - ET 200pro motor starter
2-12 GWA 4NEB 950 5661-02 DS 04
2.9.1 Diagnosis via ’HW Config’ in STEP7
1. On your PC or programming device, start the SIMATIC Manager and open
the 'HW Config' window.
2. Open the "Online" station
3. Simulate the various errors and observe the signals in the status window
'DP slave diagnosis', for example:
- Switch off voltages 1L+ and / or 2L+
- Switch off maintenance switch
In the following diagram, e.g., a motor starter is diagnosed at connector slot 7.
Figure 2-5: View in the status window 'DP slave diagnosis'
Your project path
Assembly state – IM 154-.