SIMATIC - ET 200pro motor starter
10-46 GWA 4NEB 950 5661-02 DS 04
Depending on the type, signals are stored in:
• Data record DS 75 (see Chapter D.3.5)
• Data record DS 92 (see Chapter D.3.7)
• Process image of the inputs PAE
Parameter assignment
Parameterization active Yes / No
Incorrect parameter value
)
Parameter not correct
Parameter change illegal in the ON state
)
Attempted parameter change not permit-
ted when motor is running.
Incorrect parameter number
1)
Specifies the first non-accepted parameter
(parameter ID no.)
Parameter block CPU / Master active Motor starter ignores parameters from the
PLC, but informs the PLC that parameters
are OK.
No external start-up parameters received Signal indicating whether new parameters
were received from the PLC after power
ON or motor restart.
Statistical data
Maximum pointer deleted
1)
Statistical data for preventive diagnosis
has been deleted
1) Signaling bits that can be reset using "Trip reset"
Signals Meaning
Table 10-31: Communication – signals (cont.)
To Next Page
Loading...
