Siemens Simodrive 611 Planning Guide

5
05.01
5.2 Feed control with standard interface and analog setpoint interface 6SN1118–0A_11–0AA1
5-107
 Siemens AG 2001 All rights reserved
SIMODRIVE 611 Planning Guide (PJU) – 05.01 Edition
5.2 Feed control with standard interface and analog setpoint
interface 6SN1118–0A_11–0AA1
For operating motors 1FT5... a control module with standard interface is also
available. It is available as 1 and 2–axis version. All of the axis–specific settings
are made on the plug–in control module.
1–axis version
2–axis version
9
Adapt
TN
KP
T
Drift
22
9
65
14
56
9
663
AS2
AS1
9
22
9
65
14
56
2
1
–X321
–X331
T
T
Adapt
TN
KP
Drift
Adapt
TN
kp
Drift
9
663
AS2
AS1
–X332
9
22
9
65
14
56
1
2
X
T
A
M
M
W
M
W
X
T
A
M
M
W
X
T
A
M
0.8 Nm
0.8 Nm
M3 / 0.8 Nm M3 / 0.8 Nm
Version label
Fig. 5-3 Feed control with standard interface
Note
When using non–PELV circuits at terminals AS1, AS2, connector coding must
be used so that the connectors cannot be interchanged (refer to EN60204–1,
Section 6.4).
Order No. of the coding connector, refer to Catalog NC 60.
Feed control with
standard interface
5 Control Modules

Siemens Simodrive 611 Specifications

General

Brand	Siemens
Model	Simodrive 611
Category	Media Converter
Language	English