3
05.01
3.4 Direct position sensing
3-56
Siemens AG 2001 All rights reserved
SIMODRIVE 611 Planning Guide (PJU) – 05.01 Edition
3.2 Motor encoder
The motors are equipped with various encoder systems for rotor position and
speed sensing.
Reference: /PJM/ Planning Guide, Motors
1FT5 motors can be optionally ordered with a mounted or integrated encoder
system for position sensing.
Table 3-1 shows the assignment of SIMODRIVE units to the servo/main spindle
motor types.
3.3 Indirect position and motor speed sensing
The various possibilities for indirect position and speed sensing and for
positioning the motor shaft as a function of the drive configuration (SINUMERIK,
SIMODRIVE and motor) are listed in Tables 3-2 and 3-3 (Section 3.5).
3.4 Direct position sensing
3.4.1 Encoder systems which can be evaluated
The various possibilities for direct position sensing to position as a function of
the drive configuration (SINUMERIK, SIMODRIVE and motor) and the encoder
system used are listed in Tables 3-4 and 3-5 (Section 3.5).
We recommend that measuring systems with sinusoidal voltage signals are
used due to the higher data transmission reliability and integrity.
3 Motor Selection, Position/Speed Sensing