5
05.01
5.7 Control module ”SIMODRIVE 611 universal”
5-127
Siemens AG 2001 All rights reserved
SIMODRIVE 611 Planning Guide (PJU) – 05.01 Edition
5.7 Control module ”SIMODRIVE 611 universal”
The control module ”SIMODRIVE 611 universal” is used in the SIMODRIVE 611
system and includes two independent drive controls. However, the board can
also be operated in the one–axis mode or in one–axis power modules.
All of the drive–specific settings on the control board can be made as follows:
S using the “SimoCom U“ parameterizing and start–up tool
S using the display and operator unit on the front of the module
S via PROFIBUS–DP (parameter area, PKW area)
Note
The control module is described in detail in:
Reference: /FBU/, Description of Functions SIMODRIVE 611 universal
Description
5 Control Modules
To Next Page
Loading...
