Siemens Simodrive 611 Planning Guide

5
05.01
5.1 Feed control with user–friendly and analog setpoint interface 6SN1118–0AA11–0AA1
5-101
 Siemens AG 2001 All rights reserved
SIMODRIVE 611 Planning Guide (PJU) – 05.01 Edition
5.1 Feed control with user–friendly and analog setpoint
interface 6SN1118–0AA11–0AA1
A control module with user–friendly interface is available when using1FT5...
motors. It is only available as 1–axis version. An additional parameter board is
required, which can be used to set all of the axis–specific settings. It can be
inserted from the front.
This control board can be optionally expanded with the main spindle function
option board to be able to handle the requirements of main spindle operation.
Version label
R
–X312
673
674
672
299
297
296
294
293
291
290
288
289
6
16
258
44
96
24
20
23
22
9
65
9
663
AS2
AS1
14
56
126
127
214
216
114
115
108
110
162
75
61
102
M3 / 0.8 Nm
0.8 Nm
M3 / 0.8 Nm
n
off
TN
kp
Drift
Fig. 5-1 Feed control with user–friendly interface
Note
When using non–PELV circuits at terminals AS1, AS2, connector coding must
be used so that the connectors cannot be interchanged (refer to EN60204–1,
Section 6.4).
Order No. of the coding, refer to Catalog NC 60.
Feed control with
user–friendly
interface
5 Control Modules

Siemens Simodrive 611 Specifications

General

Brand	Siemens
Model	Simodrive 611
Category	Media Converter
Language	English