Siemens Simodrive 611 Planning Guide

3
05.01
3.7 Ordering information
3-79
 Siemens AG 2001 All rights reserved
SIMODRIVE 611 Planning Guide (PJU) – 05.01 Edition
3.7 Ordering information
Order Nos. for the specified components, refer to the relevant Catalog
S Pre–assembled encoder cables with refer to Catalog NC Z
appropriate maximum permissible
cable lengths
S SVE signal amplification refer to Catalog NC 60
S HGL module refer to Catalog NC 60
S Toothed wheel encoder and the refer to Catalog NC Z
required diagnostics box or NC 60
for adjustment
S For drives with an analog speed setpoint interface, the encoder systems are
evaluated in the numerical control to sense the direct and indirect position.
When using Siemens controls, the encoder systems which can be evaluated
can be taken from the appropriate catalogs.
The same is true for the associated Order Nos. for the controls and measu-
ring circuit boards.
J
3 Motor Selection, Position/Speed Sensing

Siemens Simodrive 611 Specifications

General

Brand	Siemens
Model	Simodrive 611
Category	Media Converter
Language	English