Operation
7.5 Communication via PROFIBUS DP
SINAMICS DCP
238 Operating Instructions, 09/2019, A5E34382853K
7. The "I/O address" column displays the start address for every DO. Select the start
address of the DO data to be read. In example 268: If the complete data of the publisher
is not read, then set this using the "Length" column. You may also offset the start address
for the request so that data can be read out in the middle of the DO telegram.
Figure 7-29 Configuring the direct data exchange nodes
8. The "Direct data exchange - Overview" tab shows you the configured direct data
exchange relationships which correspond to the current status of the configuration in HW
Config.
Figure 7-30 Direct data exchange - overview
To Next Page
Loading...
