SimCom SIM7500 Series

Smart Machine Smart Decision
SIM7500_SIM7600 Series_AT Command Manual_V1.07 2017-12-25
247
+IPREX: (0,300,600,1200,2400,4800,9600,19200,38400,57600,115200,230400,460800,921600,
3000000,3200000,3686400)
OK
AT+IPREX=115200
OK
AT+IPREX=0
OK
12.2 AT+CFGRI Indicate RI when using URC
Description
This command is used to configure whether pulling down <URC time>milliseconds the RI pin of
UART when URC reported. If <status> is 1, host may be wake up by RI pin, add setting <URC
time
>,
<SMS time
>
pulling down
time
of RI pin.
SIM PIN References
NO Vendor
Syntax
Test Command Responses
AT+CFGRI=? +CFGRI: (range of supported <status>s), (range of supported
<URC time>s), (range of supported <SMS time>s)
OK
Read Command Responses
AT+CFGRI?
+CFGRI: <status>,<URC time>,<SMS time>
OK
Write Command Responses
AT+CFGRI=<status>,<URC
time>,<SMS time>
OK
ERROR
Execution Command Responses
AT+CFGRI Set <status> = 0
Set <URC time> = 60
Set <SMS time> = 120
OK
Defined values
<status>
0 off
1 on
<URC time>
a numeric parameter which is number of milliseconds to assert RI delay to reset RI. The range is
SIMCOM CONFIDENTIAL FILE