SimCom SIM7500 Series

Smart Machine Smart Decision
SIM7500_SIM7600 Series_AT Command Manual_V1.07 2017-12-25
376
Test Command
Responses
AT+CGPSAUTO=? +CGPSAUTO:( list of supported <auto>s)
OK
Read Command Responses
AT+CGPSAUTO? +CGPSAUTO:<auto>
OK
Write Command Responses
AT+CGPSAUTO=<auto>
OK
ERROR
Defined values
<auto>
0 – Non-automatic
1 – automatic
Examples
AT+CGPSAUTO=1
OK
17.8 AT+CGPSNMEA Configure NMEA sentence type
Description
This command is used to configure NMEA output sentences which are generated by the gpsOne
engine when position data is available.
NOTE: If nmea bit 2 GPGSV doesn’t configure, GPGSV sentence also doesn’t output on
AT/modem port even set AT+CGPSFTM=1.
SIM PIN References
NO Vendor
Syntax
Test Command
Responses
AT+CGPSNMEA=? +CGPSNMEA: (scope of <nmea>),(scope of <bdnmea>)
OK
Read Command Responses
AT+CGPSNMEA?
+CGPSNMEA: <nmea>,<bdnmea>
OK
Write Command Responses
AT+CGPSNMEA=<nmea>[, OK
SIMCOM CONFIDENTIAL FILE