SimCom SIM7500 Series

Smart Machine Smart Decision
SIM7500_SIM7600 Series_AT Command Manual_V1.07 2017-12-25
379
Defined values
<method>
0 – Control plane
1 – User plane
Examples
AT+CGPSMD=1
OK
17.11 AT+CGPSFTM Start GPS test mode
Description
This command is used to start GPS test mode.
NOTE:
1. If test mode starts, the URC will report on AT port, Modem port and UART port.
2. If testing on actual signal, <SV> should be ignore
d, and GPS must be started by AT+CGPS,
AT+CGPSCOLD or AT+CGPSHOT.
3. If testing on GPS signal simulate equipment, <SV> must be choiced
, and GPS will start
automatically.
4. URC sentence will report every 1 second.
SIM PIN References
NO
Vendor
Syntax
Test Command Responses
AT+CGPSFTM=? OK
Read Command Responses
AT+CGPSFTM? +CGPSFTM: <on/off>
OK
Write Command
Responses
AT+CGPSFTM=<on/off> OK
ERROR
Defined values
<on/off>
0 – Close test mode
1 – Start test mode
<CNo>
Satellite CNo value. Floating value.
SIMCOM CONFIDENTIAL FILE