SimCom SIM7500 Series User Manual

Smart Machine Smart Decision
SIM7500_SIM7600 Series_AT Command Manual_V1.07 2017-12-25
386
Bit 2 – UP MS-assisted
Bit 3 – CP MS-based (2G)
Bit 4 – CP MS-assisted (2G)
Bit 5 – CP UE-based (3G)
Bit 6 – CP UE-assisted (3G)
Bit 7 – NOT USED
Bit 8 – UP MS-based (4G)
Bit 9 – UP MS-assisted(4G)
Bit 10 – CP MS-based (4G)
Bit 11 – CP MS-assisted (4G)
Set the desired mode sentence bit(s). If multiple modes are desired, “OR” the desired bits together.
Example, support standalone, UP MS-based and UP MS-assisted, set Binary value 0000 0111, is 7.
Examples
AT+CGPSPMD=127
OK
17.18 AT+CGPSMSB Configure based mode switch to standalone
Description
This command is used to configure AGPS based mode switching to standalone mode automatically
or not.
SIM PIN References
NO Vendor
Syntax
Test Command
Responses
AT+CGPSMSB=? +CGPSMSB: (scope of <mode>)
OK
Read Command Responses
AT+CGPSMSB? +CGPSMSB: <mode>
OK
Write Command Responses
AT+CGPSMSB=<mode> OK
ERROR
Defined values
<mode>
0 – Don’t switch to standalone mode automatically
SIMCOM CONFIDENTIAL FILE

SimCom SIM7500 Series Specifications

General

Brand	SimCom
Model	SIM7500 Series
Category	Control Unit
Language	English