SimCom SIM7500 Series

Smart Machine Smart Decision
SIM7500_SIM7600 Series_AT Command Manual_V1.07 2017-12-25
388
17.20 AT+CGPSNOTIFY LCS respond positioning request
Description
This command is used to respond to the incoming request for positioning request message.
SIM PIN References
NO Vendor
Syntax
Test Command Responses
AT+CGPSNOTIFY=? +CGPSNOTIFY: (list of supported <resp>s)
OK
Write Command
Responses
AT+CGPSNOTIFY=<resp> OK
ERROR
Defined values
<resp>
0 – LCS notify verify accept
1 – LCS notify verify deny
2 – LCS notify verify no response
Examples
AT+CGPSNOTIFY=?
+CGPSNOTIFY: (0-2)
OK
AT+CGPSNOTIFY=0
OK
17.21 AT+CGPSMODE Configure GPS and GLONASS mode
Description
This command is used to configure GPS and GLONASS start mode, so if you configured by this
command, you should reboot the device.
SIM PIN References
NO Vendor
SIMCOM CONFIDENTIAL FILE