Smart Machine Smart Decision
SIM7500_SIM7600 Series_AT Command Manual_V1.07 2017-12-25
9.6 AT+CGTFT Traffic Flow Template
Description
This command allows the TE to specify a Packet Filter - PF for a Traffic Flow Template - TFT that
is used in the GGSN in UMTS/GPRS and Packet GW in EPS for routing of packets onto different
QoS flows towards the TE. The concept is further described in the 3GPP TS 23.060
consists of from one and u
p to 16 Packet F
i
lters, each identi
fied by a unique
<packet filter
identifier>. A Packet Filter also has an <evaluation precedence index> that is unique within all TFTs
associated with all PDP contexts that are associated with the same PDP address.
SIM PIN References
YES 3GPP TS 27.007
Syntax
AT+CGTFT=? +CGTFT: <PDP_type>,(list of supported
identifier>s),(list of supported
index>s),(list of supported
<source address and subnet
mask>s),(list of supported
<protocol number (ipv4) / next header
(ipv6)>s),(list of supported <destination port range>
supported <source port range>s),(list of supported
parameter index (spi)>s),(list of supported
(ipv4) and mask / traffic class (ipv6) and mask>
<flow label (ipv6)>s)
[<CR><LF>+CGTFT: <PDP_type>,(list of supported <packet filter
identifier>s),(list of supported
index>s),(list of supported <source address and subnet
mask>s),(list of supported
<protocol number (ipv4) / next header
(ipv6)>s),(list of supported <destination port range>
supported <source port range>s),(list of supported
parameter index (spi)>s),(list of supported <type of servi
(ipv4) and mask / traffic class (ipv6) and mask>
<flow label (ipv6)>s)
[...]]
OK
ERROR
Read Command Responses
AT+CGTFT? +CGTFT: [<cid>,<packet filter identifier>,
index>,<source address and subnet mask>,
/ next header (ipv6)>,<destination port range>,
To Next Page
Loading...
Need help?
General
