SimCom SIM7500 Series

Smart Machine Smart Decision
SIM7500_SIM7600 Series_AT Command Manual_V1.07 2017-12-25
293
ERROR
Defined values
<ip_address>
A string parameter that identifies the IP address of current active socket PDP.
<err_info>
A string parameter that displays the cause of occurring error.
Examples
AT + I PA D D R
+IPADDR: 10.71.155.118
OK
15.2.10 AT+CIPFILTERSET IP filter configuration
Description
This command is used to enable the IP filter feature in the multi-PDP mode. The IP filter is a
feature which to support embedded TCP/IP protocol applications while the mobile device is in a
PPP call.
SIM PIN References
YES Vendor
Syntax
Test Command
Responses
AT+CIPFILTERSET=? +CIPFILTERSET: (0-9),(0,1)
OK
ERROR
Read Command
Responses
AT+CIPFILTERSET? +CIPFILTERSET: <enabled_flag>
+CIPFILTERSET: 0,<enabled_flag>
+CIPFILTERSET: 1,<enabled_flag>
…
OK
Write Command
Responses
AT+CIPFILTERSET=<link_
num>,<enabled_flag>
OK
If ERROR occurred
SIMCOM CONFIDENTIAL FILE