Spectra Precision Focus 30 - Page 374

Chapter 6
Adjustment and Verification
Focus 30/35 Service Manual 6 - 120 P/N 79000035_SM, Version 1.5
Fig. 6-95 Servo side cover with Holder Side Cover
3 Start up instrument /
PASS.
See page 7-3how to set-up
the instrument.
4 Start the software. Select
Gearbox adjustment
from
Servo & angle unit in
Maintenance & Service and
press
Run operation.
5 Determine the
Reference point
A. Select
Adjust vertical
gearbox
.
B. Push the
Reference
point
button to start
the test.
The Vertical
drive turns two
rotation to find
the closest
position
between Coarse
drive pinion and
Tension gear as
reference point
for the
adjustment.
The reference
point is shown
on
Results.
It takes app. 12
minutes.
Item Performance Action Result Notes