Spectra Stack Tape Library - Page 111

Set the general encryption settings as required. If you are making multiple changes,
you can select all changes and then click Submit once.
• To change the configured default encryption mode for a new partition, select the
encryption mode and then click Submit at the bottom of the page.
• To apply the default settings to all existing partitions, click Apply to all existing
partitions and then click Submit at the bottom of the page.
• By default, only the security user is allowed to change encryption configurations.
To allow the administrator user to change encryption settings select the Allow
Administrator encryption configuration during Expert Partition Wizard check box
and then click Submit at the bottom of the page.
• The encryption mode can be configured for each partition in the Set Encryption
Mode per Partition pane. Select the encryption mode for each partition and then
click Submit.
JANUARY 2023 111
SPECTRA STACK LIBRARY
USER GUIDE
CHAPTER 3 - CONFIGURING AND USING ENCRYPTION