CHAPTER 3 - CONFIGURING THE LIBRARY
This chapter contains instructions for configuring the Spectra Stack library. Before
using this chapter, install the library using the Spectra Stack Library Quick Start Guide.
Using the Initial Configuration Wizard 60
Saving, Restoring, and Resetting the Library Configuration 61
Saving the Library Configuration 62
Verify the Configuration Backup File 63
Restoring the Library Configuration 63
Resetting to the Default Settings 64
Configuring the Date and Time Format 65
Setting the Time Zone 66
Setting the Date and Time Format 67
Setting the Date and Time 67
Enabling SNTP (Simple Network Time Protocol) Synchronization 68
Configuring Media Barcode Compatibility Checking 69
Modify Barcode Label Checksum Type 70
Add a License Key 71
Configuring the Library Network Settings 72
Reset the Internal IP Range 74
Configuring SNMP 76
Configuring Event Notification Parameters 79
Configuring Tape Drives 81
Enabling or Disabling EE Ports 83
Configuring Library Partitions 84
Using the Basic Partition Wizard 85
Using the Expert Partition Wizard 88
Configure User Accounts 95
Configure User Account Settings 95
Configure Local User Accounts 97
Configure LDAP 99
JANUARY 2023 58
SPECTRA STACK LIBRARY
USER GUIDE
CHAPTER 3 - CONFIGURING THE LIBRARY
To Next Page
Loading...
