CONFIGURING KMIP
If you plan to use KMIP encryption key management in some or all of your partitions,
use the Key Management Interoperability Protocol (KMIP) Wizard to configure use of
KMIP key management servers with the library. Access to the wizard from the
Encryption menu on the RMI is only available to the Security user and requires the
KMIP license key (see Configuring and Using Encryption on page109).
For additional information on configuring KMIP servers for use with the library, see
the documentation that came with your KMIP server.
Before running the wizard, verify that:
• The library configuration is complete, including defining all library partitions.
• The KMIP server is available on the network and has been configured for use with
this library.
Use the following instructions to set up KMIP encryption management.
1. Select Configuration > Encryption > KMIP Wizard. The Wizard Information
screen displays.
Figure58 The KMIP Wizard Information screen.
JANUARY 2023 112
SPECTRA STACK LIBRARY
USER GUIDE
CHAPTER 3 - CONFIGURING AND USING ENCRYPTION
To Next Page
Loading...
