WARNING EVENTS
Event Code Message Text and Description Details and Solution
4000
A reported drive canister fan
speed is too slow.
Ensure that there are no obstructions
to the drive fans.
4001
There is a Fibre Channel Loop
ID conflict.
Change the FC to fabric or use a
different loop setting.
4002
A drive sent a clean request. Clean the drive with an approved
cleaning cartridge.
4003
The drive configuration failed. 1. Remove the drive from the
library, reinsert it and then
retry the operation.
2. If the drive installed is a
different LTO generation than
the drive previously installed,
reset the library defaults and
then reconfigure the drive.
3. Check the drive dump for
more information. See
Downloading Drive Logs on
page203.
4004
The drive status request failed. 1. Remove the drive from the
library, reinsert it and then
retry the operation.
2. If the problem persists, reset
the drive.
3. Check the drive dump for
more information. See
Downloading Drive Logs on
page203.
4005
Drive is reporting a critical
TapeAlert.
1. Power cycle the drive and then
verify whether the drive
reports the same TapeAlert.
JANUARY 2023 240
SPECTRA STACK LIBRARY
USER GUIDE
CHAPTER 9 - EVENT CODES
To Next Page
Loading...
