Wellness Test
The wellness test performs a general health check on the library functionality by
running the following tests:
• Basic Hardware Review
• Robotics Initialization Test
• Barcode Scanning Test
• Magazine/EE Port Unlock Motor Test
• Move Media Test
Keep the following in mind when running the Wellness test:
• Running the test requires at least one drive and one tape cartridge in the library.
• After the test has started, the Stop Test button is active. Clicking Stop Test aborts
the wellness test, but not before the current test has completed.
• The test operates over the entire library and does not take into account partition
configuration.
• During the test the library is offline.
• The Info column notifies the user of the status and result of each test.
To run the system test, navigate to the Maintenance > Library Tests > Wellness Test
screen, and then click Start Test.
Figure109 The Wellness Test screen.
JANUARY 2023 193
SPECTRA STACK LIBRARY
USER GUIDE
CHAPTER 7 - MAINTAINING THE LIBRARY
To Next Page
Loading...
