CHAPTER 2 - USING THE BLUEVISION
INTERFACE
This chapter provides information on using the BlueVision interface.
Using the Operator Control Panel 48
Using the Remote Management Interface 49
Library User Types 50
Logging into the Library 51
Using the Library Main Screen 52
Top Banner Elements 53
Left Pane Elements 54
Right Pane Elements 56
Center Pane Elements 56
The library provides two main interfaces:
• Operator Control Panel (OCP) - With the OCP, you can monitor, configure, and
control the library from the LCD screen on the controller module.
• Remote Management Interface (RMI) - With the RMI, you can monitor, configure,
and control the library from a web browser. The RMI hosts a dedicated, protected
website that displays a graphical representation of the library.
The OCP and RMI are similar in design and functionality.
Before using the RMI, you must configure the library network settings and set the
administrator password with the OCP. This is typically done using the Initial
Configuration Wizard, see Using the Initial Configuration Wizard on page60.
When possible, it is recommended that the RMI be used as the primary library
interface because the web interface provides access to additional features, such as
configuring SNMP, IPv6, encryption, and partitions, includes online help, and is
easier to use.
JANUARY 2023 47
SPECTRA STACK LIBRARY
USER GUIDE
CHAPTER 2 - USING THE BLUEVISION INTERFACE
To Next Page
Loading...
