3. Using the Protocol drop-down menu, select IPv4, IPv6, or both.
• If you selected IPv4 or IPv4 & IPv6:
i. If necessary, click IPv4 to expand the section.
ii. Using the Method drop-down menu, select either DHCP or Static
addressing.
iii. If you are configuring a static IP address, enter the Address, Netmask,
and Gateway addresses.
iv. If desired, enter DNS server information.
• If you selected IPv6 or IPv4 & IPv6:
i. If necessary, click IPv6 to expand the section.
ii. Using the Method drop-down menu, select Static or Stateless.
iii. If you are configuring a static IP address, enter the Address, Prefix
Length, and Gateway.
iv. If desired, enter DNS server information.
4. Click Submit.
IMPORTANT
To view the network settings set using the DHCP or Stateless method, use the
OCP and see Viewing Network Status on page166.
Note: If you are using the RMI to access the Spectra Stack library and you have changed
the IP address, you lose your connection to the user interface when you click
Submit. To re-establish the connection, enter the new IP address in your browser
and log in again.
JANUARY 2023 73
SPECTRA STACK LIBRARY
USER GUIDE
CHAPTER 3 - CONFIGURING THE LIBRARY
To Next Page
Loading...
