The parking brake is applied.
NOTE
Keeping the push button (1) pressed for an
extended time or pressing it multiple times
makes the truck brake harder.
"Safe parking" function
This function monitors the braking effect after
the truck is parked. If a sensor is fitted on the
lift mast (variant), the function also checks
whether the fork carriage is lowered.
This function alerts the driver with an audible
warning signal if:
●
The driver leaves the driver's seat but the
parking brake could not be applied.
●
The driver leaves the driver's seat without
lowering the fork carriage (variant).
●
The driver attempts to switch off the truck
but the parking brake could not be applied.
●
The truck starts moving within 20 seconds
after the parking brake was applied.
Activating and intervening in the "Safe parking" function
Cause Effect
The driver's seat is vacated. The electric park-
ing brake cannot be applied or previously could
not be applied.
The following message is shown on the display:
Parking brake cannot be applied.
- To acknowledge this, press the Softkey.
If the driver’s seat is vacated, a warning signal
sounds. Sitting on the driver's seat silences the
warning signal.
The truck needs to be switched off. The electric
parking brake cannot be applied or previously
could not be applied.
The truck cannot be switched off. A warning
signal sounds.
The following messages are shown on the dis-
play:
Parking brake cannot be ap-
plied.
- To acknowledge this, press the Softkey.
Switch off truck anyway?
- To acknowledge this, press the Softkey.
Secure the truck to prevent it
rolling away.
- Secure the truck with wedges so that it cannot
roll away.
- To acknowledge this, press the
Softkey.
Only now can the truck be switched off.
Operation
4
Driving
212 56368011531 EN - 01/2021 - 05
To Next Page
