4F-16 Electronic Stability Program:
) C1022
Right-front wheel speed
sensor or encoder failure
Abnormal wheel speed sensor
signal is detected.
{ *1 {
) C1023 Yaw rate sensor failure
• Yaw rate sensor signal is out of
range.
• Vehicle behavior and yaw rate
signal is disagreed.
——{
) C1024
Steering angle sensor circuit
failure
• Steering angle sensor internal
defect is detected by CPU in
steering angle sensor.
• Steering angle sensor signal is
out of specified range.
——{
) C1025
Left-front wheel speed
sensor circuit failure
Wheel sensor signal is out of
specified range.
{ *1 {
) C1026
Left-front wheel speed
sensor or encoder failure
Abnormal wheel speed sensor
signal is detected.
{ *1 {
) C1027
ESP® OFF switch circuit
failure
Mechanical switch failure, failure in
switch wiring is shorted to ground.
———
) C1028
Master cylinder pressure
sensor circuit failure
Input signal voltage from master
cylinder pressure sensor in ESP®
control module is too high or low.
——{
) C1031
Right-rear wheel speed
sensor circuit failure
Wheel sensor signal is out of
specified range.
{ *1 {
) C1032
Right-rear wheel speed
sensor or encoder failure
Abnormal wheel speed sensor
signal is detected.
{ *1 {
) C1034
Yaw rate / G sensor
assembly power supply
failure
Power supply voltage of yaw rate /
G sensor assembly is too high when
ignition switch OFF.
——{
Power supply voltage of yaw rate /
G sensor assembly is too low when
ignition switch ON.
) C1035
Left-rear wheel speed
sensor circuit failure
Wheel sensor signal is out of
specified range.
{ *1 {
) C1036
Lef
t-rear wheel speed
sensor or encoder failure
Abnormal wheel speed sensor
signal is detected.
{ *1 {
) C1037
Steering angle sensor power
supply failure
Power supply voltage to steering
angle sensor is too low.
——{
) C1038
Steering angle sensor detect
rolling counter failure from
ESP® control module
ESP® control module rolling
counter failure is detected by
steering angle sensor.
——{
) C1039
Yaw rate / G sensor
assembly internal failure
Yaw rate / G sensor assembly
internal failure is detected.
——{
) C1040
Stability control system
function failure
Stability control is active for more
than specified time without yaw rate
change.
——{
DTC (displayed
on SUZUKI scan
tool)
Diagnostic Items
Detecting condition (DTC will
beset when detecting)
ABS
warning
lamp
EBD
warning
lamp
ESP®
warning
lamp