Suzuki SWIFT 2005 User Manual

Electronic Stability Program: 4F-17
) C1041
Right-front inlet solenoid
valve circuit failure
Mismatching solenoid output and
solenoid monitor is detected.
{{{
) C1042
Right-front outlet solenoid
valve circuit failure
{{{
) C1043
Master cylinder cut solenoid
valve circuit No.1 failure
{{{
) C1044
Master cylinder cut solenoid
valve circuit No.2 failure
{{{
) C1045
Left-front inlet solenoid valve
circuit failure
{{{
) C1046
Left-front outlet solenoid
valve circuit failure
{{{
) C1051
Right-rear inlet solenoid
valve circuit failure
{{{
) C1052
Right-rear outlet solenoid
valve circuit failure
{{{
) C1053
Low pressure solenoid valve
circuit No.1 failure
{{{
) C1054
Low pressure solenoid valve
circuit No.2 failure
{{{
) C1055
Left-rear inlet solenoid valve
circuit failure
{{{
) C1056
Left-rear outlet solenoid
valve circuit failure
{{{
) C1057 *2
ESP® control module power
supply circuit failure
ESP® control module power supply
voltage is too high.
{{{
ESP® control module power supply
voltage is too low.
{ *4 {
) C1061
Pump motor and/or motor
circuit failure
Defective pump motor and/or motor
power supply voltage is too low.
{ — {
) C1063
Solenoid valve power supply
driver circuit failure
Mismatching solenoid output and
solenoid monitor is detected.
{{{
) C1071
ESP
® con
trol module
internal defect
ESP® control module internal
defect is detected.
{{{
) C1073
Lost communication with
yaw rate / G sensor
assembly
CAN line communication error in
ESP® control module and yaw rate
/ G sensor assembly is detected.
——{
) C1075
Steering angle sensor
calibration incomplete *3
Missing steering angle sensor
calibration point data is detected.
——{
) C1076
Master cylinder pressure
sensor calibration
incomplete
Master cylinder pressure sensor
calibration is incompleted.
——{
) C1078
Lateral G sensor in yaw rate
/ G sensor assembly
calibration incomplete
Lateral G sensor in yaw rate / G
sensor assembly calibration is
incompleted.
——{
) C1090
Invalid communication with
ECM
ESP® control module rolling
counter failure is detected by ECM.
——{
) C1091 ECM data in CAN line failure
ECM sent invalid signal to ESP®
control module.
——{
) C1094
Invalid torque control
communication with ECM
Reception error of torque control
signal with ECM
——{
) U1073
Control module
communication bus off
Transmission error that is
inconsistent between transmission
data and transmission monitor
(CAN bus monitor) data is detected
more than 7 times continuously.
——{
DTC (displayed
on SUZUKI scan
tool)
Diagnostic Items
Detecting condition (DTC will
beset when detecting)
ABS
warning
lamp
EBD
warning
lamp
ESP®
warning
lamp

Suzuki SWIFT 2005 Specifications

General

Brand	Suzuki
Model	SWIFT 2005
Category	Automobile
Language	English