SAVE OPTIONS Controlling of the data storing in the instrument’s memory, sub-list of FILE list 5 - 41
SAVE STAT. Controlling of the statistics savings, position of SAVE OPTIONS sub-list 5 - 42
SAVE Saving files in the instrument’s memory, position of FILE list 5 - 38
SAVE Saving the configuration of the instrument in the instrument’s memory, position of
FILE SETUP list 5 - 38
SCALE Setting the scale for vibration measurements, position of DISPLAY SCALE sub-list 5 - 4
SETUP Settings of the instrument’s parameters, main list (function of the push-button) 5 - 16
SHIFT MODE Selection of few push-buttons mode, sub-list of SETUP list 5 - 24
SHIFT Selection of the working mode of <SHIFT> push-button, position of
SHIFT MODE sub-list 5 - 24
SOURCE Selection of the triggering signal, position of TRIGGER SETUP sub-list 4 - 33
SPECTRUM Measurement results presentation mode (graphical), position of DISPLAY sub-list 5 - 1
SPECTRUM Selection of 1/1 OCTAVE analysis parameters, sub-list of
PROFILES SETUP sub-list 4 - 65
SPECTRUM Selection of 1/3 OCTAVE analysis parameters, sub-list of
PROFILES SETUP sub-list 4 - 77
ST/SP Selection of the working mode of <START / STOP> push-button, position of
SHIFT MODE sub-list 5 - 24
STANDARD Selection of the STANDARD of the measurement of vibration dose, sub-list of
HAV/WBV DOSE list 5 - 34
START DELAY Setting start delay before the start of measurement, position of
STATISTICS Measurement results presentation mode (graphical), position of DISPLAY sub-list 5 - 1
TIMER Programming of the instrument’s internal timer, position of SETUP list 5 - 17
TOTAL VALUE Selection the weighted filter, sub-list of DISPLAY SETUP / CHANNEL x list 5 –5
TRIGGER SETUP Selection of mode and parameters of triggering, sub-list of INPUT list 4 - 32
TRIGGER Switching triggering on and off, position of TRIGGER SETUP sub-list 4 - 32
UNIT LABEL Checking specification of the instrument, position of DISPLAY list 5 - 15
USER FILTERS Introduction of 1/3 octave filter coefficients, sub-list of SETUP list 5 - 19
VECTOR DEFINITION Selecting of the vector coefficient, sub-list of SETUP list 5 - 30
VEL Setting the reference level for velocity measurements, position of
REFERENCE LEVEL sub-list 5 - 27
VIBRATION UNITS Selection of the vibration units, position of SETUP list 5 - 28
WBV CALCULATOR Selection of DOSE measurements, position of FUNCTION sub-list 5 - 62
X-ZOOM Scaling of the horizontal axis of the graphical presentation, position of
DISPLAY SCALE sub-list 5 - 4
To Next Page
Loading...