SVAN 948 USER MANUAL
3 - 7
v DISPLAY (one of the main lists available after pressing the <MENU> push-button)
DISPLAY MODES (sub-list); it enables the user to activate ([√
√√
√]) or switch off ([ ]) the available
modes of result’s presentation
§ SPECTRUM (position); available values: [√
√√
√] or [ ]; this position is not active in the SLM or
VLM mode
§ 3 PROFILES (position); available values: [√
√√
√] or [ ]
§ STATISTICS: (position); available values: [√
√√
√] or [ ]
§ PLOT: (position); available values: [√
√√
√] or [ ]
DISPLAY SETUP (sub-list)
§ CHANNEL x
• DISPLAY SCALE: (sub-list)
o SCALE: (position); available values of the scale of graphical modes of the result’s
presentation:
LIN (linear), LOG (logarithmic) - in the case of vibration measurements and
LOG (logarithmic) - in the case of sound measurements
o DYNAMIC: (position); available values of the dynamics of graphical modes of the
result’s presentation: 80dB, 40dB, 20dB, 10dB
o X-ZOOM: (position); it informs the user about the multiplier for the horizontal axis
of the graphical modes of the result’s presentation): 1x
• TOTAL VALUES
o TOTAL 1: (sub-list) enables to select the weighted filter to be used for the
calculation of the TOTAL value in the first profile
FILTER: (position); available values of the weighted filters:
• in the case of sound measurements: A, SUSR1, SUSR2, SUSR3 or any
other sent to the unit by means of the interface
• in the case of vibration measurements: HP, VUSR1, VUSR2, VUSR3 or
any other sent to the unit by means of the interface
TYPE: (position available only for vibration measurements); available values
if VUSR1, VUSR2 or VUSR3 was selected in the previous position: ACC,
VEL and DIL; if the HP filter was selected this position is not displayed
CAL. F.: (position available only for vibration measurements); accessible if
VUSR1, VUSR2 or VUSR3 was selected in the FILTER position; if the HP
filter was selected (the filter which was set in the 1
st
channel) this position is
not displayed; available values from -60.0dB to 60.0dB with 0.1dB or 1 dB
step
o TOTAL 2: (sub-list) enables one to select the weighted filter to be used for the
calculation of the TOTAL value in the second profile
FILTER: (position); available values of the weighted filters:
• in the case of sound measurements: C, SUSR1, SUSR2, SUSR3 or any
other sent to the unit by means of the interface
• in the case of vibration measurements: CH, VUSR1, VUSR2, VUSR3 or
any other sent to the unit by means of the interface
TYPE: (position available only for vibration measurements); available values
if VUSR1, VUSR2 or VUSR3 was selected in the previous position: ACC,
VEL and DIL; if the CH filter was selected (the filter which was set in the 2
nd
channel) this position is not displayed
CAL. F.: (position available only for vibration measurements); accessible if
VUSR1, VUSR2 or VUSR3 was selected in the FILTER position; if the CH
filter was selected (the filter which was set in the 2
nd
channel) this position is
not displayed; available values from -60.0dB to 60.0dB with 0.1dB or 1 dB
step
To Next Page
Loading...