SVAN 948 USER MANUAL .
3 - 16
VIBRATION UNITS (sub-list which has the meaning only for vibration measurements)
§ VIBRATION UNITS (position); it enables the user to set METRIC (e.g. m/s
2
, m/s, m) or NON-
METRIC units (e.g. g, ips, mil)
WARNINGS (sub-list)
§ RES.NOT SAVE: (position); it enables the user to switch on or off the warning that the results
of the measurement were not saved in the memory; available values: [√
√√
√] or [ ]
§ VECTOR DEF. (sub-list) it enables the user to select coefficients needed to calculate
vibration vector, which is taken into account during the calculation of the measurement
results.
§ K1, K2, K3, K4: the coefficients set in the instrument, there are needed to calculate VECTO.
HAV/WBV DOSE (sub-list) it enables the user to select parameters presenting the EXPOSURE
and VIBRATION DOSE measurements.
§ MEASURE DOSE (position) it enables the user to switch on (ENABLED) or switch off
(DISABLED) the measurement of vibration dose.
§ EXPOSURE TIME (position) it enables the user to set the exposure time of the vibration
signal.
§ AXIS SETUP (position) it enables the user to assign each axis of accelerometer to the
number of channels.
§ STANDARDS (position) it enables the user to select standard, which determine the limits of
measured vibration. Up to the internal software version named as 2.11 the UNITED
KINGDOM (U.K.) and ITALY standards are available. Those positions inform about limits of
vibration dose in defined standard. The user can also define the standards by him. In order to
set own limits, the user has to select the position USER
To Next Page
Loading...