Introduction the filter coefficients for 1/3 (1/1) OCTAVE analysis - USER FILTERS 5 - 19
Setting the coefficients of the user filters set - EDIT (position) 5 - 21
Setting the coefficients of the user filters - CLEAR 5 - 21
Selection of statistics levels t be saved in a file - STAT. LEVELS 5 - 22
Selection of the external mode - EXT. I/O SETUP 5 - 22
Selection of few push-buttons mode - SHIFT MODE 5 - 24
Selection of the working mode of <SHIFT> push-button - SHIFT 5 - 24
Selection of the working mode of <START / STOP> push-button - ST/SP 5 - 24
Return to the factory made settings - CLEAR SETUP 5 - 25
Selection of detector’s type in the LEQ (RMS) calculations - RMS INTEGRATION 5 - 26
Setting the reference signal in vibration measurements - REFERENCE LEVEL 5 - 26
Setting the reference level of the acceleration signal - ACC 5 - 27
Setting the reference level of the velocity signal - VEL 5 - 27
Setting the reference level of the displacement signal - DIL 5 - 27
Selection of the vibration units - VIBRATION UNITS 5 - 28
Selection of the warnings - WARNINGS 5 - 29
Saving the measurement results in a file - RES.NOT SAVE 5 - 29
Selection of the vector coefficient - VECTOR DEF. 5 - 30
Selection of the vibration dose - HAV/WBV DOSE 5 - 31
Settings of the parameters of vibration dose - MEASURE DOSE 5 - 32
Settings of the parameters of vibration dose - EXPOSURE TIME 5 - 32
Settings of the parameters of vibration dose - AXIS SETUP 5 - 33
Selection of the standard of vibration dose - STANDARDS 5 - 34
5.3. SAVING THE MEASUREMENT RESULTS 5 - 36
Saving files 5 - 36
Selection of the file’s operation - FILE 5 - 37
Saving files in the instrument’s memory - SAVE and SAVE NEXT 5 - 38
Controlling the data storing in the instrument’s memory - SAVE OPTIONS 5 - 41
Saving of the filters to the RAM memory - RAM FILE 5 - 41
Replacement of the existing files by the new ones - REPLACE 5 - 41
Controlling of the measurement statistics savings - SAVE STAT. 5 - 42
Controlling of the measurement results savings - AUTO SAVE 5 - 42
Loading the files with the measurement results - LOAD 5 - 43
Removing a file with the measurement results from memory - DELETE 5 - 45
Removing all files with measurement results from memory - DELETE ALL 5 - 46
Memory merging - DEFRAGMENTATION 5 - 47
Removing all files with results from buffer’s memory - CLEAR BUFFER 5 - 48
Checking the contents of the memory - CATALOGUE 5 - 49
Checking the free space in the memory - FREE SPACE 5 - 50
Saving setup in the instrument’s memory - SAVE SETUP and SAVE SETUP NEXT 5 - 51
Loading the files with the configuration - LOAD SETUP 5 - 53
Operations in buffer 5 - 56
To Next Page
Loading...