Selection of 1/3 OCTAVE analysis parameters for vibration signal - SPECTRUM 4 - 77
Selection of 1/3 OCTAVE analysis result of vibration signal to be saved in the buffer’s file -
BUFFER 4 - 78
Selection of the result which triggers registration in BUFFER mode in 1/3 OCTAVE analysis
of vibration signal 4 - 78
4.6. DOSE ANALYSER 4 - 80
One profile mode of measurement results presentation 4 - 80
3 PROFILES mode of the measurement results presentation 4 - 83
4.6.1. HAV and WBV measurement parameters setting 4 - 84
Measurement parameters setting - INPUT 4 - 84
Setting parameters in channels and for octave analysis - CHANNELS SETUP 4 - 85
Setting parameters in a channel - CHANNEL x 4 - 85
Selection of the instrument - MODE 4 - 85
Selection of the measurement range - RANGE 4 - 86
Selection of the weighting filter in VLM - FILTER 4 - 87
Selection of the RMS detector in VLM - DETECTOR 4 - 88
Selection of measurement parameters - BUFFERS SETUP 4 - 88
Selection of the result to be saved in the buffer’s file - BUFFERS 4 - 88
5. AUXILIARY FUNCTIONS 5 - 1
5.1. DATA AVAILABLE ON THE SCREEN - DISPLAY LIST 5 - 1
Selection of the modes of measurement results presentation - DISPLAY MODES 5 - 1
Selection of the parameters in graphical results presentation - DISPLAY SETUP 5 - 3
Setting of the scale in graphical results presentation - DISPLAY SCALE 5 - 4
Scaling of the vertical axis of the graphical presentation - DYNAMIC 5 - 4
Scaling of the horizontal axis of the graphical presentation - X-ZOOM 5 - 4
Selection of the weighted filters - TOTAL VALUES 5 - 5
Selection of the weighted filters for the 1
st
profile - TOTAL 1 5 - 5
Selection of the weighted filters for the 2
nd
profile - TOTAL 2 5 - 6
Selection of the weighted filters for the 3
rd
profile - TOTAL 3 5 - 6
Selection of spectrum type - SPECTRUM TYPE 5 - 7
Selection of the buffer’s file to the display presentation - BUFFER VIEW 5 - 8
Checking the state of the internal battery - BATTERY 5 - 12
Setting the contrast of the display - CONTRAST 5 - 13
Setting the backlight parameters - BACKLIGHT 5 - 14
Automatic switch off of the backlight - TIMEOUT 5 - 14
Setting the brightness of the backlight - BRIGHTNESS 5 - 14
Checking specification of the instrument - UNIT LABEL 5 - 15
5.2. SETUP MENU 5 - 16
Programming of the instrument’s internal timer - TIMER 5 - 17
Programming of the instrument’s internal Real Time Clock - RTC 5 - 18
Setting the conditions for the diffuse field measurements - FIELD CORRECTION 5 - 18
To Next Page
Loading...