60
TimeHub 5500 TL1 Reference Manual
Commands
097-55501-02 Issue 5: June 2003
SSSSSSSSSSS SSSS S SSSSS SSSSSSS S SSS S SSSSS S
2
Retrieve Alarm Condition
This command displays alarm information. The command format is:
RTRV-ALM[-TSG]::[<aid>]:<ctag>;
Command Example:
RTRV-ALM:::SC1;
The command in this example displays all active alarms from the system.
Response Example:
SYMMBITS 98-01-02 16:30:45
M SC1 RTRV
"S0-CLK-1:MN,INDISQ,NSA,,:\"Input disqualified\""
"S0-CLK-2:MN,INDISQ,NSA,,:\"Input disqualified\""
"S0-CLK-3:MN,INDISQ,NSA,,:\"Input disqualified\""
"S0-CLK-4:MN,INDISQ,NSA,,:\"Input disqualified\""
>
SYMMBITS 98-01-02 16:30:45
M SC1 COMPLD
"S0-CLK2:MN,SNFAIL,SA,,:\Sync failure\""
;
Parameter Value Description
<aid> (Null) Displays all active alarms from the system
CLK Displays equipment related alarms from both clock cards and the
output cards, but only displays input signal related alarms from the
active clock card
CLK1 Displays both equipment related and signal related alarms from
clock card 1, regardless of whether it is the active card or not.
Alarms from other cards will not be reported.
CLK2 Displays both equipment related and signal related alarms from
clock card 2, regardless of whether it is the active card or not.
Alarms from other cards will not be reported.
To Next Page
Loading...
Need help?
General
