To Next Page

To Previous Page

TimeHub 5500 TL1 Reference Manual

Commands

097-55501-02 Issue 5: June 2003

SSSSSSSSSSSS SSSS S SSSSS SSSSSSS S SSS S SSSSS

Set Attribute

This command

sets the alarm level that an event will generate. The command format

is:

SET-ATTR[-TSG]:::<ctag>::<value>,<event>;

Parameter Value Description

<value> NONE No alarm

NONALM Non-alarmed

MINOR Minor alarm

MAJOR Major alarm

FAIL Critical alarm

<event> CLKGONE The management card cannot detect the presence of the

indicated clock card

CLKFAIL A hardware or firmware failure has occurred on the

indicated clock card

CLKWARM The clock card is warming up, and the card is not yet

active

EXCD24HR The indicated clock card has been in holdover for over 24

ECCRDMM A different connector card exists than the one specified

through the TL1 command. Specified outputs have been

disabled

EPROTMM There are less than two output driver cards in the indicated

output pair

NVERROR The non-volatile random access memory has failed on the

indicated card

OPCDFL A hardware or firmware failure has occurred on the

indicated output driver card(s) or active clock card

OPCDNA The clock cards cannot communicate with the indicated

output driver card

OPCDNP The management card cannot detect the presence of a

required output driver card

SNFAIL An alarm signal is present within the shelf that has not been

identified by the card generating the alarm signal

CLKOFFL The indicated clock card is offline

Symmetricom TimeHub 5500 Reference Manual

Other manuals for Symmetricom TimeHub 5500