Symmetricom TimeHub 5500 Reference Manual

2
TimeHub 5500 TL1 Reference Manual
99
Commands
097-55501-02 Issue 5: June 2003
2
5
3
SSSSSSSSSSSS SSSS S SSSSS SSSSSSS S SSS S SSSSS
Switch Duplex Equipment
This command forces the system to switch the inactive clock card to the active
state. The effect is the same as pressing the Force Active pushbutton on the
inactive clock card. The command format is:
SW-DX-EQPT:[<tid>]:CLK:<ctag>;
Note:
This command is primarily for testing purposes.
Command Example:
SW-DX-EQPT::CLK:SC1;
The command in this example causes the active clock card to switch to the
secondary clock card.
Response Example:
<IP SC1
<
SYMMBITS 00-07-22 15:52:31
M SC1 COMPLD
;
SYMMBITS 00-07-22 15:52:31
A 0095 REPT EVT TSG
"CLK1:CLKACTV,SC,02-22,15-52-31:\"CLK Active\""

Symmetricom TimeHub 5500 Specifications

General

Brand	Symmetricom
Model	TimeHub 5500
Category	Data Loggers
Language	English