246 (End)
TimeHub 5500 TL1 Reference Manual
Troubleshooting
097-55501-02 Issue 5: June 2003
SSSSSSSSSSS SSSS S SSSSS SSSSSSS S SSS S SSSSS S
5
This page intentionally left blank.
Error Responses
Error responses appear when a command is denied. The error response format is
shown below:
^^^<sid>^<date>^<time>
M^^<ctag>^DENY
^^^<errcde>
^^^/* <error message> */
;
DENY indicates that the command was denied due to an error. The error code
<errcde> parameter indicates the error type or cause of the error.
Table N lists error codes, their description, and the action to take.
Table N. Error Code Troubleshooting
Error Code Description Action
IBEX Block, extra Check the command syntax.
IDNV Input, data not valid Enter valid data.
IIAC Input, invalid access identifier (aid) Enter the valid aid.
IICM Invalid command Check the command syntax.
IICT Input, invalid correlation tag (ctag) Enter the valid ctag.
IIPG Input, invalid parameter grouping Check the command syntax.
IISP Input, invalid syntax or punctuation Enter the valid syntax or punctuation.
IITA Input, invalid target identifier (tid) Enter the valid tid.
INUP Input, non-null unimplemented parameter Check the command syntax.
IPMS Input, parameter missing Check the command syntax.
IPNV Input, parameter not valid Enter the valid parameter.
ISCH Input, syntax, invalid character Enter the valid syntax.
ISPC Input, syntax, invalid punctuation Enter the valid syntax.
PICC Privilege, illegal command code The user is not authorized.
PIUC Privilege, illegal user code The user is not authorized.
PIUI Privilege, illegal user identity The user is not authorized.
SARB Status, all resources busy Try again later.
SROF Status, requested operation failed Check the command description.
SSRE Status, system resources exceeded Try again later.
IBEX Block, extra Check the command syntax.
To Previous Page
Loading...
Need help?
General
