Technogym Group Cycle D92 - Writing the Wep Key Number; Checking Connection Type; Writing the Console Ip Address

9.2.3.3 WRITING THE WEP KEY NUMBER
Command Notes
Command @SWEPKEYINDEX index#
Sets the WEP key used to connect to the access
point with WEP encryption.
Table 39
The parameter indexindicatesthenumberoftheWEPkeyutilised(thepermiedvaluesare1,2,3
and 4). If a WEP key is not used, enter 0. Only WEP open key mode is supported.
9.2.3.4 CHECKING CONNECTION TYPE
Command Notes
Command @RWIFICONFIG#
Displays SSID, password and type of encryption
used by the congured access point.
Table 40
The parameter ssid indicates the name of the Wi-Fi network.
9.2.3.5 WRITING THE CONSOLE IP ADDRESS
Command Notes
Command @SIPADDRESS ipaddress# Sets the console’s static IP address.
Table 41
The parameter ipaddress indicates the static IP address of the console.
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 109