Technogym Group Cycle D92 - Removing and Assembling the Pedal

11.2 REMOVING AND ASSEMBLING THE PEDAL
Figure 116
1. Rotate the pedal/pedal crank assembly
until it reaches the upright position.
2
3
Figure 117
2. Unscrew the pedal (2) from the pedal
crank (3) using a 15mm wrench (or using
the wrench provided for Bike Excite ped-
al cranks).
Figure 118
3. Apply a few drops of Loctite 2701 on the
pedal thread.
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 139