Technogym Group Cycle D92 - Software Upgrade for the New Wi-Fi; Ant+ Console

• Openthe“console_wi”sub-folder.
• Drag the fw le for the console (WFW----BA---versione.bin) to the equipment folder.
If you incorrectly try to load the SW for the new console in the old console, an error message will
appear and it will not be possible to load the SW.
• Wait for the le to copy (approx. 10 seconds);
• Disconnect the MINI USB cable from the console, the console will turn o after a few sec-
onds.
For the New Group Cycle Connect version, repeat the operations described above and
install the fw le for the wi- board (WFW----CA---versione.bin).
• When the SW update is complete, put the protective cover back on the console’s MINI USB
connector.
• Put the console back on the bike.
7.2 SOFTWARE UPGRADE FOR THE NEW WI-FI /
ANT+ CONSOLE
The SW upgrade for the new WI-FI / ANT+ console can take place in two modes:
• remotely, via Asset;
• locally, via the procedure described below:
Remove the console as described in “11.1 Removing the console”.
1. Starting situation:
• PC (laptop) switched on;
• USB-MINI USB Cable.
2. Procedure:
• ConnecttheMINIUSBcabletotheconsoleandtheUSBsockettoyourPC(theconsolebuons
will light up).
• PressthePLAY/PAUSEbuonontheconsolewithinvesecondswhiletheequipmentisreseing
(thebuonsontheconsolewillblinkslowly).
• AnAUTOPLAYpop-upwillappearonthePCforaUSBashdrivecalled“FSL LOADER”.
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 84