Technogym Group Cycle D92 - Setting the Data Send Period; Displaying the Realtime Monitor Configuration; Enabling Data Sending; Disabling Data Sending

Table 45
The parameter ip_add indicates the IP address where UNITY SELF is located. The parameter port
indicates the number of the UDP port where UNITY SELF is located.
9.2.4.2 SETTING THE DATA SEND PERIOD
Command Notes
Command @SRTMPOLLING tsend# Sets the data send period to UNITY SELF.
The parameter tsend indicates the data sending period to UNITY SELF (expressed in seconds).
9.2.4.3 DISPLAYING THE REALTIME MONITOR CONFIGURATION
Command Notes
Command @RRTMCONFIG# Displays the UNITY SELF conguration.
Table 46
9.2.4.4 ENABLING DATA SENDING
Command Notes
Command @ENABLERTM# Enables sending data to UNITY SELF.
Table 47
9.2.4.5 DISABLING DATA SENDING
Command Notes
Command @DISABLERTM# Disables sending data to UNITY SELF.
Table 48
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 111