6.6 PROCEDURE FOR REPLACING THE WATT
SENSOR ID BOARD ON GROUP CYCLES FIT
WITH REV. 2 ELECTRONICS
ATTENTION: Do not unscrew the plate fastening and regulation screws (1) and (2) to
1
2
Figure 42
1. Remove the guards necessary to reach the cover of the Wa Sensor ID board, located on the left
side of the equipment.
2. Remove the fastening screws (A) that fasten the Wa Sensor ID board cover to the plate.
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 66
To Next Page
Loading...
