New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 229
16.5 REVISION4.2
Changed paragraph §11.3 PLAY REGULATION FOR HORIZONTAL VERTICAL REGULATIONS:
detailed description and changed the procedure.
Changed paragraph §2.7.1 OLD ELECTRONICS CABLE DIAGRAM (REV.1) and §2.7.2 NEW
ELECTRONICS CABLE DIAGRAM (REV. 2): updated the SNs.
Changed paragraph §6.10 BRAKE CALIBRATION: added step relative to checking the calibration
template.
New paragraph §6.10.1 CHECKING THE CALIBRATION TEMPLATE: detailed description of the
calibration template thickness check.
New paragraph § 6.13 DIAGNOSTICS OF THE NEW WI-FI/ANT+ CONSOLE VIA THE nRF
CONNECT APP (BLE SIGNAL CHECK).
New paragraph §6.14 EQUIPMENT TESTING AFTER THE INTERVENTION OF TECHNICAL
SERVICE.
Changed paragraph §7 EQUIPMENT SOFTWARE LOADER: aligned the paragraph with the
Equipment Software Loader Manual rev. 4.3.
16.6 REVISION 4.3
New paragraph §6.8.5 LOOSENING OF THE FLYWHEEL SCREWS: Indicated the type of Loctite
and the tightening torque for the aluminium disc screws in the case of problems with the loosening
of the ywheel screws.
Changed paragraph §10.5.3 REMOVING THE FLYWHEEL, TRANSMISSION BELT AND GENER-
ATOR BELT: During the reassembly procedure of the ywheel, indicated the type of Loctite and
the tightening torque of the aluminium disc screws to prevent problems of the screws loosening.
16.7 REVISION 4.4
Modied title and content in paragraph §6.10.2 LACK OF PRECISION IN THE WATT VALUES:
added procedure for the mechanical regulation of the brake position and saving of the positions, if
the mechanical parts (brake unit and Hall sensor) of the machine have not been replaced.
Modied paragraph §10.6.2 REMOVING HANDLEBAR HORIZONTAL SLIDING UNIT:
indicated tightening torque and use of generic grease when re-assembling the pin of the quick-re-
lease lever and bearing.
16.8 REVISION 5.0
Main modications:
SHOWN ON THE DISPLAY.
Group Cycle Class Conguration: detailed the procedure at §8.
To Next Page
Loading...
