Technogym Group Cycle D92 - Writing the Gateway Address; Checking the Ip Address - Default Gateway - Netmask; Reading the Wi-Fi Power; Configuring Unity Self

9.2.3.6 WRITING THE GATEWAY ADDRESS
Command Notes
Command @SDEFGATEWAY gateway# Sets the IP address of the default gateway.
Table 42
The parameter gateway indicates the value of the IP address of the default gateway.
9.2.3.7 CHECKING THE IP ADDRESS - DEFAULT GATEWAY -
NETMASK
Command Notes
Command @RNETPARAM#
Displays the console’s IP address, the default
gateway and the netmask the console is current-
ly using (regardless of whether these have been
assigned in DHCP mode or have been cong-
ured as static).
Table 43
9.2.3.8 READING THE WI-FI POWER
Command Notes
Command @RWIFIRSSI# Shows the Wi-Fi receiving power.
Table 44
The signal must be above -85dBm (e.g. -80dBm = OK).
9.2.4 CONFIGURING UNITY SELF
9.2.4.1 SETTING PARAMETERS
Command Notes
Command @SRTMSOCKET ip_add port#
Sets the IP address and the UDP port where
UNITY SELF is located.
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 110