Technogym Group Cycle D92 - Position of Manufacturer and Product Identification Label - Position of Warning Label

2.6 POSITION OF MANUFACTURER AND PRODUCT
IDENTIFICATION LABEL - POSITION OF WARNING
LABEL
- Manufacturer name and address;
- Production site;
- Product description;
- Device class;
- European certication marking;
- Serial number and date of production;
- Product code.
Figure 3 - Position of manufacturer and product identication label
The equipment must be lifted to read the serial number. If the equipment is rested on its handlebar,
remove the display (if installed) and move the handlebar to the fully forward position so that the alu-
minium disc does not touch the ground in front of the handlebar. Alternatively, place the equipment
on its side.
Figure 4 -Position of warning label
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
Page 23